Step 1: find the cleaning utensils of the transport metal" />

日本不卡高清免费中文电影_天天干夜夜草_伊人色亚洲视频免费_网友自拍亚洲色图_草b视频在线观看_国产精品最新视频_黄片在线免费观看一区二区三区_日本亚洲欧美国产日韩图片_女生说痛男生就越赛的软件_国产精品观看

Three steps to clean the transportable metal detector correctly!

Release time：2020-12-24 11:59:42 Clicks：

The following three basic steps are to clean the metal conveyor belt, metal foam conveyor belt, etc!

Step 1: find the cleaning utensils of the transport metal detector, usually find a clean towel, wet it with water and screw it dry until it can not screw out water.

Step 2: clean the surface of the conveying metal detector. Pay attention to adjust the sensitivity of the needle detector to a low level before cleaning. If the needle detector has b / C mode, please adjust the needle detector to C mode, so as not to affect the next cleaning work due to high sensitivity. Then straighten the towel and press it tightly on the surface of the conveyor belt. Start the machine and make the machine run for more than five circles. Then wash the towel and screw it dry. Repeat this step again to wipe the conveyor belt until there is no obvious pollutant on the surface of the conveyor belt.

輸送式金屬探測器

Step 3: clean the back of the conveyor type metal detector. The operation method is to clean and screw dry the towel, pass the towel through the bottom of the conveyor belt from the lower part of the machine, straighten the towel, draw the towel to the front of the conveyor, grasp both ends of the towel, and start the machine to run the machine for several weeks. As the bottom of the conveyor belt is often dirty, it needs to be wiped many times. After several weeks of operation, take out the towel and wash it. Repeat the above steps again.
   Methods to check the cleaning effect of metal detector:
   After the needle inspection conveyor belt has passed the above two cleaning processes, adjust the mobility to level 8 or the maximum mobility, and turn on the main device to make the machine work smoothly. If the machine runs smoothly, the metal direction light of the probe does not turn on, and the clothes put in do not contain any metal impurities, the clothes can pass through the needle inspection channel smoothly, that is, the cleaning of the conveyor belt is successful!
工業(yè)金屬探測器

  The above are the three steps for the correct cleaning of the conveying metal detector and the methods for checking the cleaning effect. According to the correct cleaning method, it is beneficial to improve the use efficiency of the metal detector, reduce the equipment failure, meet the production process requirements, and ensure the safety of production and use!